July 23, 2017. I needed to drill a hole in the roof of my truck. Crazy? Yes. Necessary: Yes. Curious why? I covered that here. So. Removing the headliner. I searched and searched for visual instructions on this and didn’t find any, though I did have the FSM info which turned out to be pretty reasonable. …armed with that, I got started. First I removed the passenger seat to get some room to work. Then, the two clips in the rear of the headliner. Next, I tackled the back panel. Tape on the end of my screwdriver really helped here.…
Leave a CommentGuide Section: Interior
Removing it, sound deadening, audio work.
December 30, 2017. I've removed my dash trim (at least, the driver side) more times than I'd care to admit, and figured it was time to write up the procedure - because I remember how daunting it was the first time. Removal starts at the bottom-front of the center console, in front the gear-shift, and works it's way up and counter-clockwise to the instrument panel: Center lower cover Climate control faceplate Center panel finish Lower finish panel Ignition bezel and clock Steering column cover Instrument cluster cover Start by removing the plastic center lower cover (which contains the two 12v…
8 Comments
In the last post, I outlined the Materials and Prep necessary for sound deadening a 1st gen Tacoma. This time, we'll walk through the specifics on how to do the actual deadening. As a reminder, all you really need to do this job are the following: RAAMAudio Package 2 30 sheets of RAAMmat BXT II (56.25 sq ft). 4 1/2 yards Ensolite Foam (62.43 sq ft). 3/8" split loom - you only need about 4' to house the interior door handle rods. A sharpie, utility knife , and scissors to cut the material. A screwdriver with a plastic handle to…
10 Comments
While I believe the saying, "They don't make them like they used to," generally does apply to a 1st gen Tacoma, it most definitely does not apply to the sound deadening of these old trucks. Nearly any vehicle you get today will have better sound deadening than a 20-year old truck and after thousands of freeway miles, I decided it was finally time for some peace and quiet in the cab. Or at least, that was the plan. Oh, and while I'm definitely no audiophile, I figured I might as well put in some new speakers while I was at…
11 Comments