TL;DR - I've not really had any noticeable bed spread over the last 5 years, despite every other Tacoma seeming to have the problem. However, I've noticed recently that the gap around the tailgate is not as even as it used to be. I'm not worried for now, but I'll likely address it with and update to the bed rack.
Leave a CommentTag: bed rack
It's not natural. It's uncomfortable. It's hard. And, I know it's the right thing to do - I want to find a way to cut some weight off of the Tacoma. When I purchased the truck, Toyota listed the curb weight of a 4WD SR5 V6 Xtracab at something right around 3,500 lbs, and the gross weight (GVWR) at something near 5100 lbs. Or at least, that's what I can find on the internet in 2019, since I wasn't at all interested or concerned with those numbers at the time. Unfortunately for me - and the truck - when I…
10 Comments
TL;DR - The new rack works just fine, but I have no idea if it's preventing bed cracking until I take it off.
Leave a Comment
May 10, 2019. When I originally built my bed rack back in 2016, I was sure that the rack was going to be something that was only installed when we were out on an adventure. The rest of the time, I'd remove it using the pulley system in the garage so that the Tacoma could be it's natural self. Oh how naive I was. Turns out, there's no reason to stop adventuring in the winter, and quite frankly, the rear suspension on the truck is much more comfortable with the couple hundred extra pounds from the tent. Plus, I don't really…
4 Comments
Ever since building the bed rack, I've been happy with it. It's done everything I've asked of it and more. The CVT tent @cascadia tents has always been secure, and it's been a great way to carry the Hi-Lift, supply power to the fridge, and keep everything in the bed secure. It's also been a great height, leaving the tent even with the roof line, and allowing a good amount of space underneath for storage, not the least of which is the custom bed slide I made to hold the ARB fridge. Until now that is. You see, I've recently…
Leave a Comment
February 13, 2018. Ever since installing the bed rack and CVT the truck has been in "adventure mode." I don't mind that so much when I'm just driving around (though - it'd be nice to not haul around the extra weight all the time), but it does make me nervous to park it unattended/unsecured overnight. As such, I've been trying to come up with a plan to remove the rack and RTT (ideally at the same time), and store them. In our barely-1-car garage. At any rate, I knew the solution was going to involve either a winch or pullies…
Leave a Comment
February 14, 2017. You may recall that no too long ago I decided to purchase a CVT, and then of course realized that the truck would need a bed rack to attach said CVT. That led to my Millermatic 211 acquisition, and the realization that this bed rack was the beginning of yet another expensive hobby (metalwork). Excited to get going, I started looking for bed rack designs. I wanted something that would support the CVT - both on the road as well as deployed would position the top of the CVT "in-line" with the top of the cab -…
Leave a Comment