TL;DR - I am not happy with the lifespan I got out of the X-Axis joints on my SPC upper control arms (UCAs), so I'm going back to the original polyurethane bushing-based SPC UCAs.
9 CommentsTag: bushings
All the bushings I replaced.
TL;DR - All the new bushings I installed recently seem to be doing great.
Leave a Comment
Squeaky bushings annoy a lot of people. I am not one of those people. And so, as my bushings have squeaked over the years, I've just let them do their thing - usually until I next wash the truck at which point the squeaking stops. And so, my bushings have "lasted" for 20 years. In fact, with the exception of the bushings in the rear leaf springs - which were refreshed when I got a new leaf pack from Alcan - I think all of them are still original. Oh, and the upper control arms (UCAs) bushings have been replaced,…
10 Comments
Over time, rubber bushings wear out and need to be replaced. This happened for me recently when I Replaced All the Bushings on my Tacoma, and I figured that others could benefit from a quick little guide that shows the entire process and lists all the necessary parts for the front diff bushings. Parts Durobump Front Diff Bushings are the only parts you need for this job. Tools Misc sockets (I recommend this set from Williams, a Snap-On brand) 12mm, 14mm socket - to remove the skid plate. 19mm socket to remove front diff brackets. 21mm socket - to remove lug…
8 Comments
Over time, rubber bushings wear out and need to be replaced. This happened for me recently when I Replaced All the Bushings on my Tacoma, and I figured that others could benefit from a quick little guide that shows the entire process and lists all the necessary parts. Before getting started, I should note that when replacing the Lower Control Arm (LCA) bushings, one must remove the steering rack from its mounts. As such, this is also a good time to refresh the bushings that secure it as well, which is not a difficult process: Step-by-Step Steering Rack Bushing Replacement on a…
60 Comments
Over time, rubber bushings wear out and need to be replaced. This happened for me recently when I Replaced All the Bushings on my Tacoma, and I figured that others could benefit from a quick little guide that shows the entire process and lists all the necessary parts for replacing the bushings in the steering rack. Parts One thing to be aware of when replacing the steering rack bushings is that 1st gen Tacomas have two different bushing configurations depending on the model year - with the change happening around the 2000 model. Earlier trucks - it seems - use a…
15 Comments
TL;DR - Like lights, bushings wear out, and I'll be replacing several on the front of the truck. The LCA bushings are likely the cause of my misalignment as well, so I'll get that addressed after I replace the bushings.
Leave a Comment
I've never been a car guy. I can tell you all about the details of construction and woodworking - how the various bits of a house work, how to precision tune a saw or plane. But when I looked down and saw two flaking, worn bushings that were connected to "some bar" and my lower control arms, I wondered, "What the heck is that, and how screwed am I?" As it turns out, that was my stabilizer bar, and I wasn't really all that screwed at all. But I'm getting ahead of myself. See, the first thing I did was consult…
2 Comments