Press "Enter" to skip to content

Tag: rear shock mount relocation

Tacoma Rear Shock Relocation - Scrapping the First Attempt and Trying Again

December 17, 2018. I'm generally pretty good at building things with my hands, but in relocating the rear shocks on my first gen Toyota Tacoma, I'd royally screwed up. If you haven't read about that, I'd recommend checking out the previous post in this series - Rear Shock Relocation - Fabrication and Failure, where after I'd permanently welded a bunch of stuff to my truck, I'd discovered that I couldn't go over bumps taller than about 2-inches. Not good for adventuring out on dirt roads. But, failure is a great learning tool, and I'd spent some time figuring out why…

4 Comments

Tacoma Rear Shock Relocation - Fabrication...and Failure

December 3-4, 2018. Rear shock relocation day was finally here! Zane @Speedytech and I were up bright and early so we could be at ADS right around their opening time of 8:00am to pick up the rear shocks they'd been holding for me for the last couple of months. As generally seems to be the case when it comes to truck parts stores, we were both like kids in a candy store as we ogled around the ADS facility. Definitely quite the setup they've got going on there! Tyler, who'd been helping me with my shocks, walked us around for…

Leave a Comment

Tacoma Rear Shock Relocation - Collecting Parts and Heading South

December 1-2, 2018. For years now I've run what I'd call "work shocks" in the rear of the truck. First a set of Gabriel Hi-Jackers that I put on to carry heavy loads, then a set of Monroe MaxAir MA820's when I installed the rear lift - these shocks were great for carrying heavy loads since I could add air pressure to push the rear of the truck higher. But as truck use has changed to more exploration (perhaps even the overused "overlanding), it's become clear that the ride provided by these shocks is not ideal. The rear end takes…

Leave a Comment